startside

 - diamantkernebor

 - Fugefræsestifter

 - Fugefræsesål

 - Fugefræse diamantskiver

 - rillefræser - rilleskærer

 - glasbor og flisebor

 - Diamantslibesten 

 - Kopskive - diamant

 - diamantklinger - ringsav

 - diamantklinger - gulv/væg

 - Download

 - kontakt Diatech

 kontakt Diatech

startside

Diamantklinger til Ringsav

Diamantblade tekniske specifikationer

A HØJ-KVALITET, OMFATTENDE BLADE RANGE
HS3 - For fast cutting of hard materials, cured concrete with hard aggregate and critically hard brick pavers.

HS5 - For extended life when cutting cured concrete, masonry, stone, concrete pilings with steel, culvert pipe with steel and brick pavers.

HS8 - For maximum life, general purpose cutting of block, abrasive block, soft brick, concrete pavers and green concrete.

GC5 - For green concrete and block.

AP5 - For extra long life cutting of asphalt, asphalt over concrete and some abrasive green concrete.




GH5 - For general purpose cutting of most cured concrete, masonry or stone materials.

GH8 - For maximum life, general purpose cutting of block, abrasive block, soft brick and concrete pavers.

DH5 - Cuts most soft to medium-hard cured concrete, masonry and stone materials. Lower cost per cut and longer blade life.

DH8 For maximum life on soft brick, abrasive block and concrete pavers. Lower cost per cut and longer blade life.

DG5 - For cutting green concrete and block.

DA5 - For fast cutting of asphalt, asphalt over concrete and some abrasive green concrete.




EH5 - For general purpose cutting of concrete, masonry and stone.

EH8 - For use on a wide range of abrasive materials such as soft brick, abrasive block and green concrete, or cured concrete with soft aggregate.

EH10 - For cutting abrasive green concrete, block and asphalt – wet or dry.